The non-vibration non-slip slope is divided into a compression layer
Published:
2022-12-25
The non-vibration non-slip slope is divided into a compression layer and an anti-slip layer, which are cement-based materials. First of all, the foundation ground must meet the concrete above C25, and the surface does not have sand and shells.
The slope angle of the entrance and exit of the garage is relatively large. If there is no anti-skid treatment, it is easy to cause the vehicle to slip or collide due to the faster speed. If it is rainy and snowy, the risk factor is higher.
So how to deal with the problem of slip resistance at the entrance and exit of the garage? The quality of Carbon Cable's new materials has been recognized and supported by customers in the industry.
The non-vibration non-slip slope is divided into a compression layer and an anti-slip layer, which are cement-based materials. First of all, the foundation ground must meet the concrete above C25, and the surface does not have sand and shells. After the foundation ground is polished and cleaned, the plain ground should be sealed, and the pores of the cement ground should be sealed to ensure that the material is not absorbed and increase the adhesion of the surface. The construction process of the anti-slip layer and the anti-slip layer are the same. The anti-slip layer is mainly used to protect the foundation ground from abrasion and increase the bearing capacity of the surface. The anti-slip layer is used to increase the anti-slip coefficient of the surface and protect the safety of the vehicle.
Contact Information
Fax：0519-81092968
Website：www.cztsxc.com
Address: No.8,Lan xiang Road,West Taihu Science And Technology Industrial Park,Changzhou.
Copyright © 2022 Carbon-Explore New Material Technology Co., Ltd.